From the AS/400 command line, type the command
STRLEXSVR to start the LexiCom server.
The server will take a few minutes to start.
The server is fully started when port 1099 and the HTTP(/S) port (if using
AS2) are active.
If using only the FTP(/S) and/or HTTP(/S) protocols, the server is fully
started when port 1099 is active. Additionally, the message 'LexiCom
AS/400 process is now running.' is written to the QSYSOPR
log.
You can easily view the existence of these ports from System i Navigator
(under Network > TCP/IP Configuration > IPv4 > Connections), or you can type the WRKTCPSTS or the
netstat command from the AS/400 command line and then
select Option 3 (Work with IPv4 connection status).
To stop the Cleo LexiCom server.
Type the command ENDLEXSVR from the AS/400 command
line.
You can also stop the Cleo LexiCom
server from the Cleo LexiCom UI
running through the IFS mapped drive. Select the File > Stop AS/400 menu option.
A dialog box appears asking you to confirm that you want to stop the LexiCom
AS/400 process.
The message, 'LexiCom AS/400 process is stopping…' is
written to the QSYSOPR log.
Click on the "Yes" button and the LexiCom AS/400 process will be stopped and
the message ‘LexiCom AS/400 process has stopped.’ will be written to the
QSYSOPR log.
It may take several minutes for the server to stop, especially if the server
is currently processing messages.
You can verify the server has stopped by checking the port connections as
described above or by checking the QSYSOPR log for the
message ‘LexiCom AS/400 process has stopped.’.
When you want to start the Cleo LexiCom application
again on the AS/400, you must run the STRLEXSVR command from the AS/400 command
line.